Chatham BM by Discount Builders Merchants, Northfleet

Re-guttering a Dockyard terrace and its lead

Houses by the Dockyard were built with roof edges of their own, and much of the work on them lands there: a run that has dropped over the years, a downpipe cracked at a joint, or lead that has come away from a chimney. Find out whether the house is protected before anything else, because that answer shapes how the work can be done and what needs agreeing first.

Chatham BM is the Chatham and Luton delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

Slate roof with chimney, lead flashing and gutter

Consent and listing come first

Before measuring anything, find out whether the house is listed or stands in a conservation area. Historic England keeps the list, and Medway Council says whether listed building consent is needed for new gutters or lead. A change made first and approved later is the expensive way round, so settle it before a single length is bought.

Photograph each front and back edge from the pavement to keep a record. Note where the water runs off, and measure the length of each run, its fall and its profile. The new run should copy the profile the old one used, so the measurements and the photographs go on the order together.

The gutter and the fall that drains it

Two sizes carry most terrace work here: a 112 mm round gutter in black and a 68 mm round downpipe, both sold in 4 m lengths. Check the profile on the old run before choosing, and do not assume round because the street is round. The name on each product spells out the size and finish.

Fittings are the part that gets forgotten. Brackets go along the run at close spacing, the open end needs a cap, and the foot of each pipe needs a shoe. None of those is counted in the lines on this page, so add them to the order before it is sent.

Downpipes and where they land

Count each downpipe from the gutter down to the drain, in whole lengths, and place the joints where the pipe changes direction or meets a bend. A pipe running down the back of a terrace often discharges into a shared drain, so find out where its outlet goes before anything is cut.

Lengths stay in the garden until the fixer is up the ladder. Long pieces catch the wind like a sail, so carry them low along the pavement with the ends capped.

Lead where the roof meets the wall

Flashing is the strip of lead that seals the joint where a roof runs into brickwork, and on an older terrace it is usually the first part to lift. The yard lists lead by weight code. A Code 4 sheet in 3 m lengths and 150 mm wide is a common size for a chimney, and how far it turns up the wall sets the width needed.

Cut lead long rather than short, since a short strip cannot be stretched to fit the step. Each lap needs its own allowance, and the top edge tucks under the covering above. A roofer does the dressing, so the order only needs the material and the lengths.

Capping boards and a shared edge

A capping board is fixed over a fascia that is still sound and needs protecting. The boards here are 9 mm thick, 175 mm or 200 mm deep, and come in 5 m lengths. Plan each run around a whole number of boards, since a short offcut is hard to use anywhere else.

Terraced gutters often run the length of several houses, so one repair can reach next door. Talk with the neighbours well ahead of the day, and agree in writing who meets the cost of any shared length. Scaffold on the pavement needs its own permit from the council.

Rules of thumb

Working figures for planning an order. Check them against your drawings and the product you choose.
Gutter Run length in metres, divided by four and rounded up, plus one 4 m piece for each corner, of 112 mm round black gutter.
Downpipe Downpipe comes in 4 m lengths, 68 mm round and black. Work out the drop from gutter to drain and use whole lengths to reach it.
Lead flashing Lead by Code 4, sold in 3 m lengths and 150 mm wide. Count the laps where pieces meet, and the length the lead turns up the wall.
Capping board Boards are 9 mm thick and 5 m long, 175 mm or 200 mm deep. Plan the joints around whole boards.
Fall Gutter drains towards its outlet. Measure the existing fall before the old run comes down, and copy it.

The shop has calculators that turn a measurement into a quantity.

Worked order: Front and back edge of a Dockyard house

Priced with the shop's prices today, last checked , and the yard's delivery charge to ME4. Amounts are ex VAT unless marked.
Product Quantity What it is for Cost
112mm x 4m Gutter Black Round (BR042) 3 at £14.50 Front eaves of 4.8 m take two 4 m lengths, cut to fit the outlet. The back addition's 2.8 m is a separate run with its own downpipe, so it takes one more 4 m length, cut to size. £43.50
68mm x 4m Downpipe Black Round (BR203) 4 at £14.00 A downpipe at the front and one at the back, each dropping 5.5 m to the drain. Each drop takes two 4 m lengths, so four in all. £56.00
3m (150mm) Code 4 Lead 6" 2 at £35.91 Lead for the join where the back addition butts the house, 2.8 m long. Two 3 m lengths of 150 mm lead cover it with the laps included. £71.82
200mmX5m 9mm CAPPING BOARD 1 at £20.99 The 4.8 m front fascia fits one 5 m board with 0.2 m to spare. The back fascia is measured and ordered separately. £20.99
Goods £192.31
Delivery to ME4 £0.00
Delivered total ex VAT £192.31
Delivered total inc VAT £230.77

Not in this order: Brackets, end caps, outlets and shoes, nails and sealant, and any patching of the brickwork the lead is dressed into. None of those is counted in the lines on this page.

The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.

On the shop today

The products this guide talks about, from the shop's Roofing aisle. Prices last checked .

Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.

Felt, lead and gutter for Chatham roofs See all Roofing on the shop

Delivery to Chatham and Luton

ME4

Free when the goods reach £41.66 ex VAT (£49.99 inc VAT).

A smaller order pays the difference up to that amount: goods of £25.00 ex VAT (£30.00 inc VAT) pay £16.66 ex VAT (£19.99 inc VAT) for delivery.

Delivery charges by district · Contact the yard

More guides for Chatham and Luton